2 edition of Investigation of microchannel fabrication methods and particle-liquid flow characteristics in a microfluidic device. found in the catalog.
Investigation of microchannel fabrication methods and particle-liquid flow characteristics in a microfluidic device.
Clement Kim Man Kong
Published
2006
.
Written in English
Microchannel fabrication methods and the particle-liquid flow characteristics in a microfluidic system were investigated experimentally. Combination of heat press and heat bonding was tested on polycarbonate and acrylic. In heat press, the best pressing temperatures for polycarbonate and acrylic were found to be 135°C and 65°C, respectively; and the optimum pressing times were both 120 minutes. In heat bonding, the best bonding temperatures for polycarbonate and acrylic were 135°C and 60°C at bonding times of 150 and 90 minutes, respectively.In the particle-liquid flow experiments, the effect of stirring in the inlet reservoir on the particle flow in a 75mum-diameter microchannel was examined. The number of particles that entered and flowed through the microchannel was found to increase with the liquid flow rate but decrease with stirring rate. Stirring in the reservoir was found to be detrimental to particle-liquid flow since it generated particle clusters within the reservoir.
The Physical Object | |
---|---|
Pagination | 73 leaves. |
Number of Pages | 73 |
ID Numbers | |
Open Library | OL19215520M |
ISBN 10 | 9780494163146 |
Bathroom ironmongery trade catalogues 1970s.
Aerial propaganda leaflets produced by the United Nations Joint Forces for Operation Desert Storm, Persian Gulf 1991
An Easy Guide to the HP 48
The geology of the Springbok area / by J.A.H. Marais [and others]
Statistical Representation of Results of the Surveys 1995 National Assessment of Conventional Oil and Resources, Crovelli, Robert A. et al, U.S. Department of the Interior
user survey examining levels of satisfaction with the childrens library service in Nottinghamshire
Appropriation, Bureau of Fisheries. Letter from the Acting Secretary of the Treasury, transmitting a copy of a communication from the Acting Secretary of Commerce and Labor submitting an estimate of appropriation for Bureau of Fisheries.
Protected areas, conservation and development
Marketing management in general medical practice with specific refereence to health promotion.
Aliens for breakfast
Meet our new student from Japan
Metropolitan Toronto and the Greater Toronto Area
Poes Raven, its origin and genesis
Subsurface mineral resource analysis, Yucca Mountain, Nevada
A method for solution of an air traffic control problem